문자 보내
전화 번호:
Changzhou Junqi International Trade Co.,Ltd
Changzhou Junqi International Trade Co.,Ltd

고객들의 가치를 창출합니다. 완전성과 윈-윈.

제품 소개브러시리스 직류 모터 구동장치

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로

  • 브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로
  • 브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로
  • 브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로
  • 브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로
브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로
제품 상세 정보:
원래 장소: 중국
브랜드 이름: JUYI
인증: CE,
모델 번호: JYQD-V7.5E
결제 및 배송 조건:
최소 주문 수량: 1개 세트
가격: Negotiable
포장 세부 사항: PE BAG+ 판지
배달 시간: 5-10 일
지불 조건: T/T, L/C, Paypal
공급 능력: 10000sets/Month
접촉
상세 제품 설명
상품 이름: 브러시리스 직류 전동기 드라이버 보드 작업 전압: 36V-72VDC
최대 전류: 16A 사용 전류: 15A
PWM 속도 제어: 듀티 사이클 0-100 % 아날로그 전압 속도 규칙: 0-5V
무브러시: 홀 센서 브러시리스 직류 전동기를 위해 기술지원:
색: 그린 속도 펄스 신호 산출:

JYQD_V7.5E 36-72VDC 15A Working Current 3-Phase BLDC motor driver board for Hall effect BLDC Motor

 

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 0

 

Specifications

Operating Voltage DC 36V
Operating current ≤20A
Output power ≤700W
Speed control 0.1V-5V or PWM input
Operating temperature -40-85℃
Operating humidity ≤90%
Protection Overload protection, locked-rotor protection, over-current protection
Functions Speed pulse signal output, soft reversing (485,CAN port optional)
Overall dimension 63X42.5X33mm (L*W*H)
Net weight 38g
Optional component

Speed regulating potentiometer

external 5 digit tachometer


 

 

 

 

 

 

 

 

 

 

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 1

ATTENTION:

1: This brushless DC motor driver board is widely apply to DC Brushless with Hall sensor (120°angle) three-wire motors


2:please make sure to add heat sink when the output power more than 60W.

 
When installing the heat sink, please add insulation layer for 6pcs MOS. It will damage the driver board permanently without insulation,and also apply Heat-Conducting Silicone Grease on the insulation for better cooling.

3: As the BLDC motor factory may use different Hall sequence,if the motor start abnormal, can't start or the current getting to high, please adjust the sequence of the Hall, or the driver will be damaged.

 

4:Please offer the right voltage to the driver, do not exceed the operating range. and the driver has built-in 5V for speed control, DO NOT connect extra power supply( 5V ) into the driver for speed controlling, it will damage the driver.

 

Wiring instructions

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 2

1. Control port

5V Driver board internal output voltage, external potentiometer or switch for speed adjustment and reversing operation

Z/F Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or connect to GND is reverse direction.

VR Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm ,connect with GND when input PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100%

EL Enable port control. Connect 5V or no connect to allow operation, connect GND to forbid operation.

Signal Speed pulse signal output

GNDUsed for Drive board internal control

2. Power port

MA ----motor phase A

MB ---- motor phase B

MC---- motor phase C

GND ----DC-

VCC----DC +

3:Hall sensor port

Ha--- Hall a

Hb---Hall b

Hc---Hall c

GND---GND

5V---5V output

4. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead to abnormal driving, affecting the normal use.

5. Control port distance: 2.54mm,Power port distance:3.96 mm

6. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.

 

 

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 3

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 4

 

Mounting dimension

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 5

 

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 6

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 7브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 8

We can supply extra assy for this driver board connector wires, heatsink.

브러쉬리스 모터를 위한 DC 36V 15A 700W JYQD-V7.5E 전자 속도 제어기 회로 9

 

연락처 세부 사항
Changzhou Junqi International Trade Co.,Ltd

담당자: Ivanzhu

전화 번호: 0086-13961407941

회사에 직접 문의 보내기
Changzhou Junqi International Trade Co.,Ltd
No.28 스헌위안 Rd, 창주 시, 치안스, 중국
전화 번호:86-1396-1407941
모바일 사이트 개인 정보 정책 | 중국 좋은 품질 무브러시 Dc 전동기 협력 업체. © 2021 - 2024 bldcelectricmotor.com. All Rights Reserved.